LogoLogo
Buy SoftwareBuy HardwareOpen a ticket
Rekor Edge Pro
Rekor Edge Pro
  • 📹Introduction
  • 📜Register Your Product
  • ⚡Connecting
    • Overview
    • Powering
    • Configuration Dashboard
      • Access
      • First Time Login
      • Device Settings
      • Mobile Network Settings
      • Licensing
      • Data Destination
  • 🛠️Installing
    • Overview
    • Packing List
    • Cable Interface
    • Assembly
      • SIM Card Installation
      • Sun Shield Cover
      • Mounting Bracket
    • Mounting
    • Cable Connection
    • Waterproofing and Insulation
    • Installation Checklist
  • ⚙️Configuring
    • Overview
    • Location
    • Camera Configuration
    • LPR Configuration
  • 📋Calibration Tips
    • Overview
    • Quick Reference Guide
    • Specifications, Requirements, and Capabilities
    • Calibration
    • Getting Help
Powered by GitBook
LogoLogo

Platforms

  • Rekor Discover® for Urban Mobility
  • Rekor Command® for Transportation
  • Rekor Scout® for Public Safety

Systems

  • Rekor Edge Flex™ (Classificaiton)
  • Rekor Edge Max™ (Classification)
  • Rekor Edge Pro (ALPR)
  • Rekor Edge Max™ (ALPR)

Developers

  • Vehicle Recognition SDK
  • Rekor CarCheck®
  • Rekor AutoNotice™

Resources

  • About Us
  • Customer Stories
  • Newsroom
  • Help Center

© 2025 Rekor Systems, Inc. All Rights Reserved.

On this page

Was this helpful?

  1. Connecting
  2. Configuration Dashboard

Mobile Network Settings

PreviousDevice SettingsNextLicensing

Last updated 1 month ago

Was this helpful?

The Edge Pro supports network connectivity through mobile networks if no Ethernet connection is available on site. The Edge Pro supports Verizon and AT&T SIM cards.

The SIM card must already be installed in the camera and operational in order to configure the mobile network settings and view the connections details. To install the SIM card, please follow these instructions.

Navigate to the "Mobile Network" menu on the left dashboard. Click on the "Management" page where the mobile connection, LTE module details, mobile service details, and GPS information are listed.

  1. Ensure that the Status shows "Ready" and that the "Enable" slider is on.

  2. If your mobile carrier requires a PIN, you may modify it by clicking the "Modify" button.

  3. Enter the "APN," "Username," "Password," and select the "Auth. Mode," as provided by your mobile carrier.

  4. Click "Save All" at the bottom of the screen.

Navigate to the "Mobile Network - Basic" menu on the left dashboard where the Lan Settings are listed.

  1. Select the "Type" from the drop-down menu.

  2. Enter the "IP Address," "Subnet Mask," Primary DNS," Secondary DNS," and "Gateway" address, as provided by your mobile carrier.

  3. Click "Save."

Navigate to the "Mobile Network - Embedded Firewall" menu on the left dashboard where the Firewall List is displayed. Two camera ports are already blocked by default.

  1. If your mobile carrier required embedded firewalls, click the Add button and enter the "Remote IP Address," "Remote Port," "Camera Port," and "Type."

  2. Click "Save."

⚡