LogoLogo
Buy SoftwareBuy HardwareOpen a ticket
Rekor Edge Pro
Rekor Edge Pro
  • 📹Introduction
  • 📜Register Your Product
  • ⚡Connecting
    • Overview
    • Powering
    • Configuration Dashboard
      • Access
      • First Time Login
      • Device Settings
      • Licensing
      • Data Destination
  • 🛠️Installing
    • Overview
    • Packing List
    • Cable Interface
    • Assembly
      • Sun Shield Cover
      • Mounting Bracket
    • Mounting
    • Cable Connection
    • Waterproofing and Insulation
    • Installation Checklist
  • ⚙️Configuring
    • Overview
    • Location
    • Camera Configuration
    • LPR Configuration
  • 📋Calibration Tips
    • Overview
    • Quick Reference Guide
    • Specifications, Requirements, and Capabilities
    • Calibration
    • Getting Help
Powered by GitBook
LogoLogo

Platforms

  • Rekor Discover® for Urban Mobility
  • Rekor Command® for Transportation
  • Rekor Scout® for Public Safety

Systems

  • Rekor Edge Flex™ (Classificaiton)
  • Rekor Edge Max™ (Classification)
  • Rekor Edge Pro (ALPR)
  • Rekor Edge Max™ (ALPR)

Developers

  • Vehicle Recognition SDK
  • Rekor CarCheck®
  • Rekor AutoNotice™

Resources

  • About Us
  • Customer Stories
  • Newsroom
  • Help Center

© 2025 Rekor Systems, Inc. All Rights Reserved.

On this page

Was this helpful?

  1. Installing

Mounting

PreviousMounting BracketNextCable Connection

Last updated 9 months ago

Was this helpful?

  1. Confirm that the cable outlet on the wall is large enough for the pigtails to pass through. Affix the drilling sticker to the camera installation position and ensure that the center of the sticker matches the cable outlet on the wall.

  2. Use a 5mm drill bit to drill four 35mm deep holes in the positions marked by the drilling sticker. Use a hammer to carefully drive the white plastic expansion tubes into the holes.

  3. Connect the external cabling to camera pigtails, insulate the connections (see Cable Connections), and feed the cabling through the cable entry on the wall. Fasten the tapping screws. Make sure the cable outlet at the camera base is installed facing downwards and is sealed with waterproof glue or caulking to prevent water from getting into the camera.

  4. Loosen the three hex socket bolts and adjust the camera to the required angle. Then re-tighten the screws, and adjust the position of the sunshield.

🛠️
Tighten 3 hex socket head cap
Adjust the angle of the camera
Adjust the position of the sun shield. screws after adjustment