Edge Processing Unit Installation

This guide provides instructions on how to wire the connections and install the Edge Processing Unit (EPU).

Down the PDF of the Edge Max EPU Installation Guide here:

840KB

Edge Max PU Installation Manual.pdf

PDF

Open

Power

The The EPU requires 24VDC. The site may have existing power (light pole, etc.) or may require connection to a solar kit battery. The system uses 24V power. Double check that the power is 24VDC before connecting to the EPU.

Connect the power connector to the wire using a small flat-head screwdriver to secure the wire. Ensure that the positive and negative wires are secured to the correct connection.

Run the power cable with connector through the far-right grommet of the enclosure.

Insert the power connector into the power port and secure with the screws.

NOTE: DO NOT power the Edge over the PoE ports.

Connections

1. Insert the SIM card into the SIM card slot.

Note: The SIM card must have a Static IP and the contacts must be facing up when it is inserted.

1. Plug the fan connector into the fan port.

2. Connect the GPS, Cell 1 and 2, and WiFi antenna cables to the associated connectors.

3. Connect the CAT5/CAT6 Ethernet cable(s) to the POE port(s). The other end of the cable will connect the the Edge Max camera(s).

REMEMBER TO RUN ENOUGH ETHERNET CABLE TO REACH THE CAMERA.

Enclosure Installation

1. Locate and mark the position on the pole where you plan to install the EPU.

2. Insert the band clamps into the slots on the mounting brackets on the back of the EPU enclosure.

1. Wrap the band clamps around the pole and cinch them tight. Secure the clamps by tightening the screws on the clamps.

Next we'll install the Edge Max cameras.