# Mounting ## Pole Mounting 1\. Open the hose clamps and thread them through the installation holes on the mounting bracket. Use hose clamps to affix and install the pole-mount bracket to the pole. 2\. Place the junction box on the pole-mount bracket so that the arrows of bottom point to the ground as well as. Then use 4 screws to mount the junction box on to the pole-mount bracket.
3. Use 4 screws to fix the camera onto the cover of junction box. 4. Clip the safety rope of the cover of the junction box to the bottom of the junction box. 5. Thread the cables through the junction and attach them to the camera pigtails. 6. Finally, tighten the screws to fix the cover onto the junction box in place.
7. Loosen the three hex socket bolts and adjust the camera to the required angle. Then re-tighten the screws, and adjust the position of the sunshield.
## External Wall Mounting 1. Confirm that the cable outlet on the wall is large enough for the pigtails to pass through. Affix the drilling sticker to the camera installation position and ensure that the center of the sticker matches the cable outlet on the wall. 2. Use a 5mm drill bit to drill four 35mm deep holes in the positions marked by the drilling sticker. Use a hammer to carefully drive the white plastic expansion tubes into the holes.![](https://3451193206-files.gitbook.io/~/files/v0/b/gitbook-x-prod.appspot.com/o/spaces%2FKI13VuNtb2ha2W3A2jIT%2Fuploads%2FmTt2REwf0AZwGTOJo5XH%2F2.3.1-Mounting.jpg?alt=media\&token=a263ef28-c4c9-4549-b008-0a95ca3f5e05)![](https://3451193206-files.gitbook.io/~/files/v0/b/gitbook-x-prod.appspot.com/o/spaces%2FKI13VuNtb2ha2W3A2jIT%2Fuploads%2F1SZWhNKPNDdo7TulGPhh%2F2.3.2-Mounting.jpg?alt=media\&token=871fded2-3268-431d-887a-1483712f45f0) 3. Connect the external cabling to camera pigtails, insulate the connections (see Cable Connections), and feed the cabling through the cable entry on the wall. Fasten the tapping screws. Make sure the cable outlet at the camera base is installed facing downwards and is sealed with waterproof glue or caulking to prevent water from getting into the camera.
4. Loosen the three hex socket bolts and adjust the camera to the required angle. Then re-tighten the screws, and adjust the position of the sunshield.

Tighten 3 hex socket head cap

Adjust the angle of the camera

Adjust the position of the sun shield. screws after adjustment

--- # Agent Instructions: Querying This Documentation If you need additional information that is not directly available in this page, you can query the documentation dynamically by asking a question. Perform an HTTP GET request on the current page URL with the `ask` query parameter: ``` GET https://docs.rekor.ai/edge-pro/installing/mounting.md?ask= ``` The question should be specific, self-contained, and written in natural language. The response will contain a direct answer to the question and relevant excerpts and sources from the documentation. Use this mechanism when the answer is not explicitly present in the current page, you need clarification or additional context, or you want to retrieve related documentation sections.